The short answer
We install panel murals in Bay Lake homes in 32830 by measuring the wall first, confirming the print size, then hanging panels in order from a plumb line so the image stays continuous edge to edge.
A mural is a single image split into numbered panels, and if one panel lands a quarter inch off, the whole picture shows it. That makes mural work a measuring job first and a hanging job second. For residences in Bay Lake, ZIP 32830, roughly 12 miles west of our Orlando shop, we install printed murals in bedrooms, playrooms, offices, entry halls and great rooms. Owners often choose a mural to give a guest suite or kids' room a strong theme, or to add depth to a wall with no view. Here is how we take a mural from a set of rolled panels to one continuous scene.
Measure before you order
Most mural mistakes start before the panels arrive. Custom murals are printed to a size you specify, and stock murals come in fixed dimensions. Either way, the print should be a few inches larger than the wall in both directions so there is bleed to trim at the ceiling, floor and corners. Walls in many Florida homes are not perfectly square, and a print that matches the wall exactly leaves no room to correct for that.
We can visit, measure width at several heights and height at several points, and give you the numbers to send to the printer. If the wall has a window, door or fireplace, we also note where those openings fall on the image so an important part of the scene, like a face or horizon point, does not end up cut away.
- Width measured at top, middle and bottom
- Height measured at both ends and center
- Locations of outlets, switches and vents
- Position of trim, crown and baseboard
Choosing the right mural material
Mural prints come on several substrates. Nonwoven paste-the-wall panels are the most common choice for homes because they hold dimension well and strip off dry later. Vinyl-coated panels are tougher and easier to wipe, which helps in a kids' room or a busy hallway. Peel-and-stick murals are an option for short-term rooms, but they are less forgiving to reposition across large walls and can struggle on textured surfaces in humid conditions.
For the long, hot, humid months between June and September, we lean toward a breathable nonwoven or a quality vinyl with a solid wallcovering primer underneath. That combination resists edge lift better when doors and sliders open to the heat.
Hanging panels in sequence
On installation day, we lay out every panel on the floor or a clean table in order and check that the image lines up across each joint before any paste is applied. Occasionally a print run has a misnumbered panel or a color shift, and catching it now saves the mural.
We then draw a true vertical line for the first panel rather than following a corner. Each following panel is aligned to the image on its neighbor, butted tight and rolled flat. Air is pushed out from the center toward the edges with a soft smoother so the print surface does not scuff. Once the full scene is up, we trim excess at the top and bottom with a fresh blade and clean any paste from the face right away.
A typical bedroom wall mural takes one day, including prep. Very large murals, those wrapping around a corner or ones going over a ceiling transition, can need longer.
Ideas that suit Bay Lake residences
Murals give a guest suite or children's room a personality that paint alone cannot. Owners here often lean toward tropical foliage, soft watercolor landscapes, sky scenes for ceilings, or maps and illustrated themes for a playroom. Because many homes host visitors through the year, a theme that is fun but not too personal tends to age well. We do not design artwork ourselves, but we can tell you how a chosen file will sit on your wall and where seams will fall.
If the mural will face bright windows, matte finishes keep glare down so the image stays readable through the day.
Care after installation
Keep the air conditioning running steadily for a few days after the mural goes up so the adhesive cures evenly. Avoid hanging heavy frames directly on the image for the first week. Vinyl-faced murals can be wiped with a damp, soft cloth, while uncoated paper prints should only be dusted.
We also hang murals in Lake Buena Vista, Windermere, Winter Garden, Kissimmee and Sky Lake, all within easy reach of 32830.
More services in Bay Lake
- Wallpaper Installation in Bay LakeLocal service & repairs
- Wallpaper Removal in Bay LakeLocal service & repairs
- Accent Wall Installation in Bay LakeLocal service & repairs
- Grasscloth Wallpaper Installation in Bay LakeLocal service & repairs

